Adjusting pitch bend on z3ta+

Author
sam_spade
Max Output Level: -90 dBFS
  • Total Posts : 6
  • Joined: 2010/08/19 23:40:11
  • Status: offline
2010/08/19 23:53:16 (permalink)

Adjusting pitch bend on z3ta+

Hi,

I'm new to z3ta+ and am wondering if I can change the pitch bend (up or down) up to one octave with any presets (still using preset synths for now) and if so, how I may do this? I'm using a hardware based midi keyboard to control Z3ta+ with a pitch bend wheel.

Thanks for any help.
#1

3 Replies Related Threads

    sam_spade
    Max Output Level: -90 dBFS
    • Total Posts : 6
    • Joined: 2010/08/19 23:40:11
    • Status: offline
    Re:Adjusting pitch bend on z3ta+ 2010/08/20 00:08:43 (permalink)
    Nevermind, I figured it out. :)
    #2
    mun
    Max Output Level: -90 dBFS
    • Total Posts : 3
    • Joined: 2011/07/03 09:57:39
    • Status: offline
    Re:Adjusting pitch bend on z3ta+ 2012/02/12 12:50:40 (permalink)
    Yes but you could share it with the rest of us.  Does anyone know how to easily change the normal + or - 2 semitones MIDI pitch bend to an octave or more... without delving into programming-type geek stuff (which scares the doggy-do out me).
    #3
    timswartz
    Max Output Level: -89 dBFS
    • Total Posts : 78
    • Joined: 2007/08/19 12:44:37
    • Location: Soquel, California
    • Status: offline
    Re:Adjusting pitch bend on z3ta+ 2012/02/12 13:20:21 (permalink)
    Z3TA+
    Under Oscillators, select the GL tab. You will see Bend Up and Bend Down. Each can be adjusted +/- 12. There are also some very cool bend modes - Low - only lowest note bends on a chord - High - highest note in chord bends, and Hold - only key down notes - not sustained or released notes.
     
    Z3TA+2 
    Select the Perform tab on the Synth screen. In the upper left corner you will see Bend Up and Bend Down. Each can be adjusted +/- 12.
    Bend modes - Low, High, and Hold.  Z3TA+2 also includes assignable bend scale and root. Good stuff!!!
     
    Best Regards,
    Tim
    www.DigitalSoundFactory.com
    post edited by timswartz - 2012/02/12 15:37:53
    #4
    Jump to:
    © 2024 APG vNext Commercial Version 5.1