Anyone using Motu Micro Lite Midi Interface?

Hello All,
 
I have been using My Motu Micro lite Midi Interface with Windows XP Pro, Windows 7 Pro, Windows 8.1 Pro.  The Motu Micro lite has worked well with all the the previous OS mentioned.  I then built a new computer (See specs in signature area) installed Windows 8.1 again and then updated to Windows 10 Pro. I then re-installed Windows 10 after it became activated  and performed a clean install re-formatting the hard drive and make Windows 10 a clean install. 
 
I re-installed Sonar X3e and all needed drivers and additional software needed.  I reattached all  USB and Fire-wire hardware, and the computer was booting nicely.  I then installed my last device which was the Motu Micro Lite Midi Interface, and that's when it happened, .. the 5 minute boot up.  I unplugged the Motu Micro lite from the USB port, rebooted and the SSD Hard Drive booted in about 7 seconds flat.  I reattached the Motu Micro Lite and I was back to the 5 minute Boot up problem again.   I have switched between all of the built in USB 3.0 and USB 2.0 on the motherboard and even added a USB 2.0 PCI card to the mother board but the boot up time with the Micro Lite is still around 5 minutes.  
 
I went to the Motu Website and they report their Motu Micro lite is Windows 10 ready, however, I brought this  Interface back when Windows XP was out.  There were drivers on the site but they were for Windows 8.1 OS.  I re-downloaded them again and I still receive the 5 minute boot up problem.
 
I can still use the Motu Midi Interface just as I boot up first without it being connected to the computer and then plug it into a USB port and allow it to become connected. 
 
Has anyone else experienced something like this?

Try turning off usb boot in your bios or move it down the list.