Different Session Drummer Issue

Has anyone experienced this?  Does anyone have any advice?

Sonar 8.3.1 (32 bit)

If I load SD as one would normally do it and test using the play button or by clicking on any of the drums everything is fine.  As soon as I route a MIDI drum track to it (and play the track), it stops working entirely.  If I reload the PROG, it will work again as mentioned, but it goes silent as soon as I route (and play) the MIDI drum track to it again.  Oddly, if I route the same track to the TTS-1, it works fine.  Any ideas?

Thanks in advance for any insight.

I'm just creating an audio track, clicking in the effects bin, adding as a Soft Synth.  Then I set the output of my MIDI channel to SD, and I set the output of the Audio track that has the SD enabled in the effects bin to a stereo driver pair.  Does that help?  I'm not much of a MIDI/Soft Synth guy, mostly audio.  It works for my Native Instruments Piano and TTS to do it this way.  I think I recall doing it this way in the past for SD, but I could definitely be mistaken.

Thanks.

Thanks, but it doesn't work either.  I even started a completely new project with nothing in it except for a MIDI drum pattern.  I tried creating the synth setup this way, and the behavior is identical.  All is good until I click play in the transport.  The SD creates all the sounds of the kit that I load and will play and loop within itself using its buttons. If I drag its patterns into a track, it plays them fine.  If I use a MIDI pattern that I created in staff view......it goes out to lunch.

Thanks

Can you here the notes in the staff view when you enter them?

Chappel


Can you here the notes in the staff view when you enter them?

I can hear them when I click on them or create them....It's really wierd.