Digi002 w/Sonar 3 Pro

Hello all. Quick question. Can you use the Digidesign 002 Rack as you audio interface for Sonar? If so. what needs to be done. I just brought one for a "B" room but I'm not ready to move over to ProTools yet and want to use it within Sonar, if I can.

Ok, I logged on to digidesign.com and read that I only need to download the above drivers if I have 6.2 or earlier. The 002 came with 6.4LE. So it says that the drivers are installed automatically? What else needs to be done. When I go into Sonar -> Options -> Audio, I dont see the 002 device. Although I do see it within the MIDI setup.

Ok, I changed the Driver Mode to ASIO. Thanks bill for that tip. But now I dont have any audio devices in my Playback or Record Timing? Should the following be checked: 1) Apply Dither 2) Share Drivers With Other Programs and 3) Play Effect Tails After Stopping. Also, in the General tab. When I go to click on "ASIO panel" is something suppose to happen, because nothing does.

Thanks a lot. I now see the 002 in my Sonar audio drivers, but as far as MIDI is concern I nothing but the MIDI in light is on, with a keyboard connected. Also, when I hook up an device into the line in, I dont hear anything when I play them. I do see the 002 device within my audio tracks in/out puts, but not any MIDI.
Starting to think that trying to use this with Sonar is going to be a big headache? Is anybody using the Digidesign 002 Rack with Sonar?

I'm using the digi002r with sonar 3 just fine...

Midi presented an issue as well as sonar hanging when quitting but this link by jabdo56 provides a work around.

Hey Jon thanks for the link. I was able to get my MIDI recognize by using the instructions from James. But you say that your set up is working fine. What is your audio set up. Anything that I have connected to the line-in connections of the 002r, I dont hear anything?