Trouble with controller
I just got an Oxygen 49 controller, and I'm having some trouble mapping its controls to the z3ta synth. I have done exactly what the P5 help section says to do, although some parts of it did not make sense to me. See if you can find what I'm doing wrong.
I've got the Oxygen installed and selected as a MIDI controller in P5. In the Properties page, Oxygen 49 is not a preset, so I am having to create my own preset. Here is where my problem might lie, but I can't imagine what to do. I have selected "Enable z3ta+" in the ACT section. The boxes are blue, which they should be for plug-in parameters. The problem is that none of the blue boxes say anything about effects. They should say cutoff, resonance, pan, etc. But no, they're just empty blue boxes.
Anyway, in spite of this, I go into the z3ta plug-in and I enable ACT Learn. Then I move a few sliders in z3ta, and I move a few sliders on the Oxygen. Then I disable ACT Learn. According to the instructions, I should get a dialogue box saying I have enabled certain parameters. No, this never happens. And of course, I cannot control z3ta. So what do I do?
post edited by djflux - 2008/05/17 02:45:01