ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
8.5 owner/new PC/total frustration
i just got a new i5 750 PC (thanks Jim Roseberry!) and i'm going to have to start from scratch here...i know i have the original S8 disc and i think i wrote the serial number in the manual (of course i can't find them atm), but i don't recall what Cake's policy is for installing on a new (second) PC...obviously i registered the program, but am i going to have to make a call Monday morn to Cake or will i be able to fire up the program with just the serial number (provided i can find it)? thanks...
post edited by ross g2 - 2010/08/04 20:41:46
|
CJaysMusic
Max Output Level: 0 dBFS
- Total Posts : 30423
- Joined: 2006/10/28 01:51:41
- Location: Miami - Fort Lauderdale - Davie
- Status: offline
Re:8.5.3 owner/new PC
2010/07/30 23:02:33
(permalink)
All you need is your S/N and you can get that if you log into the estore that is in this same web site. You can install it on every new pc you buy, just as long as you only have it on 2 pc's at a time and you cannot use both at the same time Cj
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/07/30 23:06:04
(permalink)
thanks CJ...i thought i would be able to get the SN as well, forgot where (been a few months)... looking forward to actually being able to use S8 to it's full potential :)
|
CJaysMusic
Max Output Level: 0 dBFS
- Total Posts : 30423
- Joined: 2006/10/28 01:51:41
- Location: Miami - Fort Lauderdale - Davie
- Status: offline
Re:8.5.3 owner/new PC
2010/07/30 23:08:38
(permalink)
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/07/30 23:22:45
(permalink)
i found my way there, but after downloading 8.5.2, it says i need an earlier version... so i think i need the disc!
|
CJaysMusic
Max Output Level: 0 dBFS
- Total Posts : 30423
- Joined: 2006/10/28 01:51:41
- Location: Miami - Fort Lauderdale - Davie
- Status: offline
Re:8.5.3 owner/new PC
2010/07/31 00:02:17
(permalink)
8.5 is a piad update You need to install 8.3, not 8.5
|
Guest
Max Output Level: -25.5 dBFS
- Total Posts : 4951
- Joined: 2009/08/03 10:50:51
- Status: online
Re:8.5.3 owner/new PC
2010/07/31 00:14:48
(permalink)
CJaysMusic All you need is your S/N and you can get that if you log into the estore that is in this same web site. You can install it on every new pc you buy, just as long as you only have it on 2 pc's at a time and you cannot use both at the same time Cj We covered that about a week ago and there is no limit stated to the number of PCs that you install it on only that it only be used on one at a time. A literal reading of the check boxes in the install would be that you can only install and use on one computer though. In the end I don't think Cake will complain as long as the original purchaser is the only one using the software.
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/07/31 01:13:31
(permalink)
CJaysMusic 8.5 is a piad update You need to install 8.3, not 8.5 ah, foggy memories...luckily i found the old email with the link to 8.3.1, dl'ing now...
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/07/31 01:17:32
(permalink)
don't look like this will work without the original S8 disc, so there you go...
|
Guest
Max Output Level: -25.5 dBFS
- Total Posts : 4951
- Joined: 2009/08/03 10:50:51
- Status: online
Re:8.5.3 owner/new PC
2010/07/31 01:19:33
(permalink)
ross g2 don't look like this will work without the original S8 disc, so there you go... 8.3 is just an update. You have to have 8 installed (and I suspect 8.1 and 8.2) to install it.
|
Jim Roseberry
Max Output Level: 0 dBFS
- Total Posts : 9871
- Joined: 2004/03/23 11:34:51
- Location: Ohio
- Status: offline
Re:8.5.3 owner/new PC
2010/07/31 10:39:23
(permalink)
Hi Ross, As has been mentioned, you'll need the Sonar 8 install DVD. Install v8 from that (using your install SN) Then, unlock Sonar with the unlock code Cakewalk issued when you registered. Finally, install the update patches to get to Sonar 8.31 IMO, The upgrade to 8.5 (currently at v8.53) is worth the cost. - You get BitBridge2 (resolves a lot of issues with 32Bit plugins that had problems being "Bridged" with BitBridge1)
- The audio engine in 8.5 was tweaked... and is a significant improvement when working at ultra low latency settings.
|
daveny5
Max Output Level: 0 dBFS
- Total Posts : 16934
- Joined: 2003/11/06 09:54:36
- Location: North Carolina
- Status: offline
Re:8.5.3 owner/new PC
2010/07/31 11:04:27
(permalink)
10Ten ross g2 don't look like this will work without the original S8 disc, so there you go... 8.3 is just an update. You have to have 8 installed (and I suspect 8.1 and 8.2) to install it. Nope, 8.3.1 will update any of the previous versions of 8 to 8.3.1.
Dave Computer: Intel i7, ASROCK H170M, 16GB/5TB+, Windows 10 Pro 64-bit, Sonar Platinum, TASCAM US-16x08, Cakewalk UM-3G MIDI I/F Instruments: SL-880 Keyboard controller, Korg 05R/W, Korg N1R, KORG Wavestation EX Axes: Fender Stratocaster, Line6 Variax 300, Ovation Acoustic, Takamine Nylon Acoustic, Behringer GX212 amp, Shure SM-58 mic, Rode NT1 condenser mic. Outboard: Mackie 1402-VLZ mixer, TC Helicon VoiceLive 2, Digitech Vocalist WS EX, PODXTLive, various stompboxes and stuff. Controllers: Korg nanoKONTROL, Wacom Bamboo Touchpad
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/08/03 01:40:36
(permalink)
Jim Roseberry Hi Ross, As has been mentioned, you'll need the Sonar 8 install DVD. Install v8 from that (using your install SN) Then, unlock Sonar with the unlock code Cakewalk issued when you registered. Finally, install the update patches to get to Sonar 8.31 IMO, The upgrade to 8.5 (currently at v8.53) is worth the cost. - You get BitBridge2 (resolves a lot of issues with 32Bit plugins that had problems being "Bridged" with BitBridge1)
- The audio engine in 8.5 was tweaked... and is a significant improvement when working at ultra low latency settings.
Hey Jim... I already own 8.5.3, I was hoping I could get away with not installing from the original S8 disc, but i found it so point's moot. Got the old Emu 1820 interface and drivers installed, seem to work fine. Going to have to read up on bit bridge, I think I'll have time to install the rest of my VSTs and such tomorrow. thanks for everyone's help, and go buy a PC from Mr. Roseberry!
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/08/04 20:39:10
(permalink)
Well, I managed to get to version 8.3.1.372, but I am unable to install any further version... It looks like the next available version I can get access to is 8.5.2, and then I would be able to install 8.5.3 (from what it says on the update page), but I'm not allowed to... again: I've paid for 8.5, It has my registration/SN visiable in "My Account"... this is getting frustrating, and seems there are way too many hoops to have to jump through to get access to something I own... EDIT: i missed an old email with the link to 8.5, now downloading...HOWEVER there has to be an easier way, i've already spent hours and i still have to install 3 more version... i
post edited by ross g2 - 2010/08/04 20:49:14
|
CJaysMusic
Max Output Level: 0 dBFS
- Total Posts : 30423
- Joined: 2006/10/28 01:51:41
- Location: Miami - Fort Lauderdale - Davie
- Status: offline
Re:8.5.3 owner/new PC
2010/08/04 20:50:23
(permalink)
It looks like the next available version I can get access to is 8.5.2, and then I would be able to install 8.5.3 (from what it says on the update page), but I'm not allowed to... 8.5 is a paid update. Did you pay for it and your not able to download it? Cj
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/08/04 21:02:59
(permalink)
CJaysMusic It looks like the next available version I can get access to is 8.5.2, and then I would be able to install 8.5.3 (from what it says on the update page), but I'm not allowed to...
8.5 is a paid update. Did you pay for it and your not able to download it? Cj read the thread title... i found the email with the 8.5 d/l info (here's to never deleting emails!) so it looks like i'm on the right path...but 5 seperate installs and hours of time leads me to believe there just has to be an easier way...
|
CJaysMusic
Max Output Level: 0 dBFS
- Total Posts : 30423
- Joined: 2006/10/28 01:51:41
- Location: Miami - Fort Lauderdale - Davie
- Status: offline
Re:8.5.3 owner/new PC
2010/08/04 21:14:24
(permalink)
Its edited and you edited the title of the thread!!! Cj
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/08/04 21:55:33
(permalink)
CJaysMusic Its edited and you edited the title of the thread!!! Cj i only added the "frustrated" part to the thread title, i also mentioned it in my reply to Jim Roseberry, and again in the next post (which i did edit, but added "EDIT: " to the edited section)...so that's three times i mentioned i own/paid for/etc 8.5... perhaps i could have simply d/l'ed version 8.5, but the point is now moot, them's the breaks...
|
jcschild
Max Output Level: -41 dBFS
- Total Posts : 3409
- Joined: 2003/11/08 00:20:10
- Location: Kentucky y'all
- Status: offline
Re:8.5.3 owner/new PC
2010/08/05 09:37:43
(permalink)
does not Jm deliver turnkey? (software/hardware already installed?) i thought he did!
Scott ADK Home of the Kentucky Fried DAW!
|
ross g2
Max Output Level: -88 dBFS
- Total Posts : 128
- Joined: 2008/01/06 12:26:31
- Status: offline
Re:8.5.3 owner/new PC
2010/08/05 09:56:29
(permalink)
jcschild does not Jm deliver turnkey? (software/hardware already installed?) i thought he did! I'm sure he does, and he did a great job on my PC and is very helpfull, responds to emails quickly, and actually answers the phone! I would not hesitate to rec him or use his services again... But I already owned Sonar Producer 8.5 and had an Emu 1820 interface. My previous PC died (an older P4/XP machine), so I wanted a current level CPU so I could use Sonar to it's full potential. My confusion/frustration came from not knowing exactly how to get 8.5.3 on to the new PC. Turns out I should have skipped installing from the disc, just should have d/l'd 8.5 and registered it on the new PC and then the updates. A call to tech support would have saved me a lot of time, live and learn...
|