More step sequencer and drum map woes..........

Further to my earlier post about snap to values when using drum maps, I can't get the step sequencer to open an existing pattern when double clicking on it if the track output is assigned to a drum map. Set straight to my drum machine is fine but if it's to a map I get the default step sequencer. i.e. no notes/hits just blank.

Anyone confirm this one for me. I'll report it anyway it's consistent for me.

I've now got two consecutive bug reports for drum map problems. Perhaps I'll make it three before the session is out.

CWBRN 5787
Step Sequencer is blank when double clicking on a clip assigned to a drum map
 
Create a step sequencer clip
Assign the track it is on to a drum map
Close the step sequencer
Double click in the bottom half of the sequencer clip
 
Expected Result
 
I would expect the step sequencer to open the clip and display the hits
 
 
Actual result
 
The step sequencer opens in it's default state. ie. no notes or pattern

Hi Seth

thanks for the reply. I appreciate that I can go route straight to a machine, which is what I'm now doing but I've a couple of drum machines and synths with decent-ish sounding drums on them that I've made some maps from that I use by default.

That's how I've discovered the problems. I appreciate it's a fairly minor issue and now I know about it I can work round it but for a while this afternoon I thought I was going crazy. Working okay on some tracks and not others with no immediately obvious differences.

Anyway I filed a couple of bug reports with the issues I've found. I doubt they are by design. Thanks again, and while we're on the subject any chance you can put a few words in the right ears for an updated drum map manager. Pretty please

CWBRN 5787 Step Sequencer is blank when double clicking on a clip assigned to a drum map

I can't reproduce this one, but as I posted in your other thread, I can confirm the PRV snap issue.


And since I usually use conventional MIDI clips with drum maps (as I did in my PRV Snap test), using the Step Sequencer's built-in drum mapping is not always an option.

  I have the same issue with Step Sequencer it doesn't open the clip when i double-click on it. I have to double-click the clip again to open it. If SS is open I can double-click any clip and it will open it. This is not how it behaved up until I installed X1c. Glad to see I am not alone with this. thanks