Edirol UA-25EX channel select?

Author
Post
Essentials Only Full Version
chrisvonwielligh
Max Output Level: -90 dBFS
  • Total Posts : 2
  • Joined: 2011/08/28 12:46:24
  • Status: offline
2011/08/28 13:05:07 (permalink)

Edirol UA-25EX channel select?

When I create a new mono track in Logic Pro, then only the left input of my interface is used, even though there's nothing plugged in. I want to record electric guitar using the Hi-Z (right) input, but logic picks up no sound in a mono track. When I plug a mic into the left input, it works fine, but I can't seem to find a way to select the right input for mono recording?

Any help?
#1

3 Replies Related Threads
    Chappel
    Max Output Level: -52.5 dBFS
    • Total Posts : 2300
    • Joined: 2009/07/11 14:55:32
    • Location: California
    • Status: offline
    Re:Edirol UA-25EX channel select? 2011/08/28 16:22:21 (permalink)
    I don't know anything about Logic Pro but I would check to make sure all the analog inputs/outputs were enabled.
    #2
    chrisvonwielligh
    Max Output Level: -90 dBFS
    • Total Posts : 2
    • Joined: 2011/08/28 12:46:24
    • Status: offline
    Re:Edirol UA-25EX channel select? 2011/08/29 12:00:53 (permalink)
    Do I do this in my DAW, or on the hardware?
    #3
    Chappel
    Max Output Level: -52.5 dBFS
    • Total Posts : 2300
    • Joined: 2009/07/11 14:55:32
    • Location: California
    • Status: offline
    Re:Edirol UA-25EX channel select? 2011/08/29 12:32:24 (permalink)
    In your DAW. If you were using Cakewalk software I could make some suggestions. The software is usually the culprit with problems like this. This is assuming the device drivers are the right ones and properly installed.
    #4
    Jump to:
    © 2024 APG vNext Commercial Version 5.1