Making Bus Sends Pre FX Bin?

Hi guys,
 
I know I can switch the sends to be pre- or post- fade, but is it possible to make the sends pre- FX bin. The signal flow diagram in the documentation shows them as post.
 
Thanks,
 
Martin

Thanks bitflipper... Yeah it's not the worst thing in the world, but because I'm using a full orchestral setup with several different sample libraries, I have LOADS of buses as it is for room placement. For example, the trumpet buses (not including tracks / Kontakt outputs) are:
 
- TRUMPETS [VSL]
- TRUMPETS [FANFARE]
- TRUMPETS [PROJECT SAM]
- TRUMPETS Early Reflections
- TRUMPETS Late Reflections
- TRUMPETS MIX
 
What I really wanted to do was place a delay on the first 3 buses (to simulate distance from the mic position: 1ft = 1ms and all that nonsense), without affecting their sends to the early and late reflection reverb buses. I'll just have to add another summing bus after the first 3 to put the delay on... It'll just add another 24 or so buses to the template - not a problem, I just like elegant solutions and this seems like a workaround! Never mind! :)
 
Thanks for the help!
 
Martin

bitflipper"Just" add another 24 busses ...my goodness, you sure put a lot of thought into reverb.

 
For someone who has Nyquist as their signature, I would hope for some solidarity from a fellow pedant
 

bitflipperSo the idea is that the "close" group gets a short delay separate from the reverb sends? Wouldn't that make it possible for your "late" reflections to arrive before the direct sound?

 
I separate the early reflections from the reverb tail, and apply different ER/LR values for each orchestra section. This is then complicated by the fact that I mix separate sample libraries (which often require different ER/LR setups, depending on how wet/dry they were recorded). The direct sound I delay by 1ms per foot, but I always make sure the direct delay is less than the ER or LR predelay.
 
:)
 
M