Sonar X3 refresh command

Hi everyone,
just a quick Q - is there a shortcut command to refresh Sonar X3 at start up
 
To explain - a while back I had a silent bus problem and a genius on the forum gave a "refresh" command - something like ctrl/alt/F1
Yes I did write it down but for the life of me I can't find it again
anyway the command solved the problem of the silent bus
just hoping that someone understands the command I am referring to
 
Any help most welcome
Best
Ed
 

Dear Kalle - your response makes several presumptions
1 That I haven't searched the forum for information on this problem
2 That I posted a thread previously re the problem or participated in the relevant thread
 
So go back to your coffee and wake up
Good morning to you too

Hi Danny
Thanks for the help
Yes losing the details of the shortcut is maddening - and it was in an obscure post - just an off the cuff comment at the very end i.e. not easily identified by the thread title- I'm sure I saved it as a favourite and copied the details - if I find it I will post it because it's like a "fix all"
Thanks again
Best
Ed

Hi gswitz
Re: Audio Engine
I don't think so - the shortcut I came across a good while back - and from what I can remember, was a command, when sonar x was open, which then brought up a dialog box warning that information may be lost if the command was continued
 
So I did not access any of the functions within Sonar x (probably x1 at the time - using x3 producer now)
I seem to remember using the command at start up of Sonar
 
I know I'm being ridiculously vague which is another reason its maddening as I knew how important the info was when I came across it - I'm sure I've saved it somewhere
 
I was just hoping that someone might recognise the command from the sketchy details
I may just try reinstalling the x3e update and see what that does because I cannot get my head around the silent bus threads - also I know I was able to fix it so easily previously
 
Thanks for your help
Best
Ed
 

I am wondering if you were referring to re-profiling - personalizing your settings again, like when you first installed your current Sonar version.
 
You can hold the 'Shift' key when launching Sonar, and I recall correctly it will re-personalize your settings.
 
I saw where you had resolved the issue, but I thought I would take a stab at your original question.

Here is some doc on the Silent Bus:
 
A new Silent Busses Detected dialog warns the user when a project contains buses or tracks that are assigned to the silent "NONE" output destination. The dialog lists all tracks and buses that have outputs or sends that are assigned to "NONE" 
 
Typically if there is a discrepancy detected between the port assignments that were saved and the ports that are used in the current configuration, the ports are set to "None" and the Silent Busses Detected dialog warns the user. 
 
This can also happen if you change your driver mode and fewer output devices are available in the new mode. 
 
Bob Bone
 

Thanks - I knew I was fairly close.
 
Bob Bone