Dimension Pro Update

Author
Post
Essentials Only Full Version
werewindle
Max Output Level: -86 dBFS
  • Total Posts : 214
  • Joined: 2015/01/21 07:53:04
  • Status: offline
2015/03/01 09:21:30 (permalink)

Dimension Pro Update

Installation fails at end saying file already in use by another program although the filename is too long to read and now Dimension Pro wants to be manually registered by will not accept the code given in Command centre although the serial number matches.
tried a full re-install but same issue.
#1

4 Replies Related Threads
    scook
    Forum Host
    • Total Posts : 24146
    • Joined: 2005/07/27 13:43:57
    • Location: TX
    • Status: offline
    Re: Dimension Pro Update 2015/03/01 09:30:06 (permalink)
    I have not installed DimPro since X1, you could try running the stand alone version of DimPro as administrator and enter the code.
    #2
    werewindle
    Max Output Level: -86 dBFS
    • Total Posts : 214
    • Joined: 2015/01/21 07:53:04
    • Status: offline
    Re: Dimension Pro Update 2015/03/01 11:05:08 (permalink)
    Tried that still rejects it. I have a feeling that last bit of the installation does the auto registration had similar issue when I 1st upgraded to Platinum and eventually it installed correctly but if this going to happen on every update it will be a right pain.
    #3
    scook
    Forum Host
    • Total Posts : 24146
    • Joined: 2005/07/27 13:43:57
    • Location: TX
    • Status: offline
    Re: Dimension Pro Update 2015/03/01 11:23:33 (permalink)
    Yes, it would be. Fortunately, DimPro is unlikely to be updated. The update shown for DimPro this time was a change to the installer, it did not affect the plug-in or content. IOW, if DimPro was installed, this update could be skipped.
    #4
    jbow
    Max Output Level: -0.2 dBFS
    • Total Posts : 7601
    • Joined: 2003/11/26 19:14:18
    • Status: offline
    Re: Dimension Pro Update 2015/03/01 11:59:57 (permalink)
    I used the CCC install but Dim Pro, everything seemed to go well but Dim Pro still says that it is ver 1.5
    I'm not sure if it updated or not. I opened it in a project and opened the freestanding 64bit using "run as administrator".
     
    Does your updated Dim Pro say 1.5 or something more?
    Thanks,
    J

    Sonar Platinum
    Studiocat Pro 16G RAM (some bells and whistles)
    HP Pavilion dm4 1165-dx (i5)-8G RAM
    Octa-Capture
    KRK Rokit-8s
    MIDI keyboards...
    Control Pad
    mics. 
    I HATE THIS CMPUTER KEYBARD!
    #5
    Jump to:
    © 2025 APG vNext Commercial Version 5.1