StudioMix in Sonar Platinum?

I've enabled Peavey StudioMix in every version of Cakewalk/Sonar for years.
How do I enable it in SP?
 
thanks,
h

Use as an ACT controller.

I created an ACT surface.  There seem to be some StudioMix presets, but they don't work correctly.
So, I tried defining the ACT myself.  It works somewhat.
Play, Stop and the volume sliders are good. The jog wheel only jogs by full measures right now.
Yes, StudioMix is an old toy, but it's always been solid and useful.
Wish there was a template already constructed to import.
 
h

If you were using it before this, it should be (almost) ready to use again in SPlat...

I found that my Studiomix setup was right where it should be next to my Markus control setup.
All I had to do was edit it to allow for the different midi port system I have now... (Just I/o needed to be selected)

I created the entry back when the Studiomix was released and it has migrated to every Sonar release since.

Last night I did a vocal session by myself using the Studiomix for transport control and my iPad for wireless visual of the screen... I was in the studio, not the control room...

Note that I do keep the faders disabled as the jitter drives me nuts and it's too hard to remember and reset all the faders every time I need to save! ;-)

If you need the setup particulars, I can probably find them. It has been near a decade since I last looked for/at that! ;-)

Keni

https://www.cakewalk.com/...rol-Surface-Installers

Your analogy is faulty.  Ford would have to produce NEW parts for the 1940's car.  Cakewalk took out a function that was already there.  BTW... I had the same problem with my Cakewalk V-Studio 700 ($5000) only 5 years old.  Does Ford make parts for a 5 year old car?... YES!
You're missing the point.  I am not the only one with complaints like these... the internet is full of them.
 
Anyway, sorry for taking up everyone's valuable time... and thanks again to constructive posting from scook.
- Signing off...

 
OK... I have 2 StudioMixes and Scook's link above fixed my problem.  I just migrated to a newer system and the new Platinum installation didn't come with StudioMix Support.  I was still able to find a solution within 5 minutes of trying to set mine up.

Three more things that I'd really like to see.

1)  Cakewalk would remember to load up the preset for the second StudioMix to control channels 9-16
2)  Or better yet, the preset load could be automated with the timeline, although I could foresee a lot of slamming
2)  The ability to use the controllers on the bus channels as well as the track channels

We can always wish, right?

On a philosophical note...

I really admire the engineering and quality that goes into good products of all types, especially musical instruments and equipment.  The StudioMix is really a cool piece.  Very well built, and I would have killed to have one of these and the equipment it interfaced with back in the analog days.  That would have been a very neat and usable setup. 

So, although I only paid about $150 for my two StudioMixes, I am very fond of them.  They're very useful and have saved me countless hours just in the transport controls alone.  Plus, my clients all think they're pretty keen, too.