Automation of PC FX Chain modules does not work. Old known issue.

First off this is an old issue that I stumbled across inadverdantly on my own. The word from Noel in an old thread I found says it is a "known limitation" as opposed to a bug and that at the time it was "too risky for a point upgrade". That was however in 2012 so maybe it's not so risky anymore with all the fixes of the core code that have happened since then.
 
I am only posting this to maybe remind the Baker's of the issue. Maybe the original "risk" is still there but maybe it is now an easy fix.
 
The problem simply put is unless you have the PC Inspector that houses the PC FX Chain Module visible it will not obey on/off automation.
 
Here is the thread where I provide (some rather confused) repro steps and details before I realized it was a known issue...
 
http://forum.cakewalk.com/EnableDisable-FX-Chain-Module-Automation-does-not-work-reliably-m3284317.aspx
 
And here is the thread I scrounged up reporting the same issue in 2012 with the reply from Noel descibing it as a "known limitation"...
 
http://forum.cakewalk.com/EnableDisable-FX-Chain-Module-Automation-does-not-work-reliably-m3284317.aspx
 
I thank sharke for posting that way back when because now I'm not going to continue driving myself bonkers trying to figure it out.
 
As I said... not sure if it can be fixed but if it can that would be absolutely brilliant.
 
Thanks.