Cakewalk by BandLab
Prev Thread
Next Thread

Pro Channel FX Chain Module - Trim Noise!

Author
Post
Essentials Only Full Version
frankbaker
Max Output Level: -90 dBFS
  • Total Posts : 4
  • Joined: 12/29/2014
  • Status: offline
November 29, 15 9:15 PM (permalink)
0

Pro Channel FX Chain Module - Trim Noise!

Noticed when using FX chain, the trim sliders (at any position either + or -)  for input and output gain introduce an nasty and incredible amount of jitter and distortion when I was using TH2.  Double clicking and reducing to 0 stops the noise.  Sounded like AC hum noise or a bad cable.  21.9.00 Platinum  UGLY! (not that there are not many workarounds) Had me pulling my hair out for a while.
#1

1 Reply Related Threads
    gswitz
    Max Output Level: -18.5 dBFS
    • Total Posts : 5694
    • Joined: 6/16/2007
    • Location: Richmond Virginia USA
    • Status: offline
    Re: Pro Channel FX Chain Module - Trim Noise! November 29, 15 10:50 PM (permalink)
    0
    I've never noticed this. TH2 has lots of noisy patches. Amps can be noisy.

    But jitter? I have a great interface and have never experienced jitter.

    Check out the TH2 meter. Are you overdriving TH2?
    post edited by gswitz - November 29, 15 11:02 PM

    StudioCat > I use Windows 10 and Sonar Platinum. I have a touch screen.
    I make some videos. This one shows how to do a physical loopback on the RME UCX to get many more equalizer nodes.
    #2
    Home » [Feedback Loop] » Problem Reports » Pro Channel FX Chain Module - Trim Noise!
    Jump to:
    © 2025 APG vNext Commercial Version 5.1