Rapture Pro still using old synth parameters controls

I was getting frustrated trying to map midi cc's between my remote controler and Rapture Pro using the midi learn.  And I discovered that Rapture is still using the old Synth parameters controls:

• 71 Resonance (aka Timbre)
• 72 Sound Release Time
• 73 Sound Attack Time
• 74 Frequency Cutoff (aka Brightness )

As it turns out I used a preset on my controller that had a row of rotary's mapped form cc71-cc78. I set this row up to control the effect sends for elements, but I kept destroying the sounds, but then I finally realized that I could tweek it back.  
 
IMHO, these behind the screen mapping should be turned off, with all the customization available for midi mapping and control of the old midi cc's are useless and way to confusing.
--------------

Why not just remap them with ACT?
 
Once completed, ACT will automatically switch controller assignment based on the virtual surface that has focus.
 
I ACT enabled Z3TA 2+ filter controls, 8-strips of the Sonar console volume and pan, and ProChannel QuadCurve EQ to my Arturia BeatStep Pro (in controller mode): It all works GREAT!
 
You can do the same with Rapture Pro and any MIDI controller surface.