Sonar Platinum: Moving clips / display new position and distance from previous position?

Author
Post
Essentials Only Full Version
siliconscientist
Max Output Level: -90 dBFS
  • Total Posts : 3
  • Joined: 2016/02/19 15:00:09
  • Status: offline
2016/04/17 09:12:36 (permalink)

Sonar Platinum: Moving clips / display new position and distance from previous position?

Hello!
I've got a question concerning Sonar Platinum...
In Sonar 7 there was a display in the status bar which showed the current position of a clip and the distance from its previous position when the clip was being moved.
Sonar Platinum just shows the current position of the clip as a small set of numbers at the start of the clip which is only visible if the start of the clip is visible (if "snap by" is selected, this display is gone too) and the distance from the previous position is not being displayed at all.
So my question is if this feature has been completely removed from Sonar Platinum or if there's a trick to activate it which I have not found yet... Any help would be greatly appreciated - thanks a lot in advance!
#1

1 Reply Related Threads
    Anderton
    Max Output Level: 0 dBFS
    • Total Posts : 14070
    • Joined: 2003/11/06 14:02:03
    • Status: offline
    Re: Sonar Platinum: Moving clips / display new position and distance from previous positio 2016/04/17 09:58:19 (permalink)
    I don't know of any way to show the offset. You can see the original start point as its time stamp in HMSF and the new one in the Inspector Clip tab (as MBT, HMSF, samples, or seconds).
     
    However you might find "Aim Assist" (keyboard shortcut toggle X) helpful in terms of seeing time line calibrations.

    The first 3 books in "The Musician's Guide to Home Recording" series are available from Hal Leonard and http://www.reverb.com. Listen to my music on http://www.YouTube.com/thecraiganderton, and visit http://www.craiganderton.com. Thanks!
    #2
    Jump to:
    © 2025 APG vNext Commercial Version 5.1