Music Creator 6 issues

I posted last week that I had no signal to record a track. Here's what I have now; After I download the driver update for presonus audiobox usb I am able to record 1 time. After I am done recording one time it goes back to no signal. I can click on arm and the track turns red but no signal at all. I can go back and update the driver again (restart computer) and again record but only one time. Any ideas are welcome, thanks again.

Hi Greg, The second recording is on the same track. Say you are putting down a guitar solo and you make a mistake, as soon as I stop recording (to re-do it) the signal is completely gone.

I am using the MME(32bit) mode. I will look up information on how to disable the onboard sound card, should I also try a different driver mode?

I switched to ASIO and it worked, I can record as many times as I want. I do have to plug headphones into the audiobox, the only issue I have left is; I only have audio in one side of my headphones, if I pan a track to the right I can't hear it, panning left is fine . It's not a bad wire because they work fine everywhere else except with my keyboard..maybe that's a clue. I have 1/8 male so I use 1/4 adapter.

Be sure you have your input set to either the LEFT or RIGHT input from your interface and NOT the stereo input. Chances are good that you are using one output from the guitar processor/amp and you are putting it into one of the two channels on the interface and have the track input set to stereo input, vs using the correct Left or Right input in the track to match your physical input.
 
If you record with the STEREO input, it will send the signal to one side only.  The result is exactly what you are describing. When you send it in to the RIGHT or LEFT input, it makes a mono track. You will hear the playback on both sides equally and you will still be able to pan it left or right in the final mix.