Windows 10 Constantly Changing Default Audio Device and/or Sampling Rates?

Author
2:43AM
Max Output Level: -68 dBFS
  • Total Posts : 1147
  • Joined: 2013/06/24 07:59:49
  • Location: PHX
  • Status: offline
2017/10/05 20:05:02 (permalink)

Windows 10 Constantly Changing Default Audio Device and/or Sampling Rates?

Is anyone else here frustrated by Windows 10 constantly and randomly changing the default audio device to something other than their external audio interface and/or changing the audio bit rate or sampling frequency?  I don't know what the hell is going on, but it seems like I need to change (and sometimes fight) to get the aforementioned settings back in order almost on a daily basis.
 
For example, just this morning, Windows 10 decided to enable, and make default, my computer monitor's audio device (which it has no speakers), i.e. the AMD High Definition Audio Device in the graphics card.  This device was previously disabled, and I haven't upgraded the graphics card drivers, which could re-enable it upon installation.  Also, sometimes audio will suddenly become unavailable for my Saffire Audio (default device) when Windows sometimes thinks it would rather be at 16-bit or 44100Hz instead.  I need to be at 24-bit and 48kHz.
 
I use my PC for additional tasks other than being a dedicated DAW PC.  So it must play Windows sounds, internet/browser audio, video editing, sound editing, etc.  I don't recall this being a problem nearly as much as when I ran Windows 7, which I sorely miss.
#1

2 Replies Related Threads

    Jim Roseberry
    Max Output Level: 0 dBFS
    • Total Posts : 9871
    • Joined: 2004/03/23 11:34:51
    • Location: Ohio
    • Status: offline
    Re: Windows 10 Constantly Changing Default Audio Device and/or Sampling Rates? 2017/10/05 21:04:25 (permalink)
    If you have any USB devices (Like a POD, Helix, Axe-FX, etc) that have a built-in audio interface, connecting these devices adds additional audio ports... which in turn bumps the Default Playback Device.
     
     

    Best Regards,

    Jim Roseberry
    jim@studiocat.com
    www.studiocat.com
    #2
    abacab
    Max Output Level: -30.5 dBFS
    • Total Posts : 4464
    • Joined: 2014/12/31 19:34:07
    • Status: offline
    Re: Windows 10 Constantly Changing Default Audio Device and/or Sampling Rates? 2017/10/06 16:36:01 (permalink)
    I ran into this a while back, but after i just left my audio interface set at 44,100Hz, Windows stopped trying to switch things around on me as far as sampling rates.  And I keep everything I am not using disabled as well.
     
    So my Windows audio and my DAW are both using my interface at the same rate.
     
    If I needed higher sampling rates, I would probably dedicate my interface to DAW use only.

    DAW: CbB; Sonar Platinum, and others ... 
    #3
    Jump to:
    © 2024 APG vNext Commercial Version 5.1