customize track inspector

Author
Post
Essentials Only Full Version
bassfaceus
Max Output Level: -90 dBFS
  • Total Posts : 14
  • Joined: 2017/06/11 06:46:21
  • Status: offline
2018/10/09 12:42:12 (permalink)

customize track inspector

hi all...i only want to see the track im working on not the output bus as well,
,but try as i might i cant figure out how to do it.
also i want to make it narrow...just like in sonar 8.5
thanks
#1

3 Replies Related Threads
    Kamikaze
    Max Output Level: -45 dBFS
    • Total Posts : 3013
    • Joined: 2015/01/15 21:38:59
    • Location: Da Nang, Vietnam
    • Status: offline
    Re: customize track inspector 2018/10/09 12:50:34 (permalink)
    Grab the divider, drag it back

     
    #2
    scook
    Forum Host
    • Total Posts : 24146
    • Joined: 2005/07/27 13:43:57
    • Location: TX
    • Status: offline
    Re: customize track inspector 2018/10/09 12:58:06 (permalink)
    You may decrease the width of the inspector container to hide the second strip but it will always contain two strips. The data shown in second strip depends on the track type. Also the inspector will expand when showing the Clip, Track or PC tab.
    #3
    bassfaceus
    Max Output Level: -90 dBFS
    • Total Posts : 14
    • Joined: 2017/06/11 06:46:21
    • Status: offline
    Re: customize track inspector 2018/10/10 01:09:30 (permalink)
    ok that was obvious (doh!), but what about making it narrow?
    Like  how we could in sonar 8.5
    post edited by bassfaceus - 2018/10/10 09:52:16
    #4
    Jump to:
    © 2024 APG vNext Commercial Version 5.1