DimPro vsti NG + S6.01 VSTScan ALWAYS
I do have the sonar6.01pe upgrade
I've been trying out Sonar6PE prior to moving projects into it.
Recently I started arranging plugin's in the plugin manager - mainly to give them friendly names and create plugin menus.
This morning on starting S6pe the vstscan started up and gave several error messages
#1 error was the vstscan couldn't find Ogg.dll and Vorbis.dll. (The only place I had these was in Vsampler which I disabled and in Nero 6 which is permenently disabled according to the vstscan)
#2. then it reported Dimension pro bad because of "Open Editor" but dimension pro was NOT open at the time.
After this, the VSTscan starts EVERYTIME I try to open S6pe with the same messages as in #1.
I tried reinstalling s6pe which went fine except that at the very end the installer said finished but would not close by itself. I closed it manually and then upgraded to 6.01pe
Same results VST always starts up when I start up S6.01pe
Once s6.01pe is open Dimension ProVSTi always gives this error message when opening files
"unknown opcode fx internal
unknown opcode fx internal
unknown opcode fx internal"
It also will not open expansion pack 1 or 2 complaining
"error uncompressing program data"
BUT the Dxi version of Dimension Pro works fine.
OBTW S5.02 still works fine - with both version of Dimension Pro and exPac 1 and 2 and it does no scan on startup. I have NOT tried to rescan plugin's fearing it would screw things up
I'm also going to post this on the Sonar web site this weekend
Any Ideas?
post edited by Fred Holmes - 2006/12/02 11:42:57