How to convert two mono tracks <--> One stereo track.

Author
Post
Essentials Only Full Version
muzdol
Max Output Level: -88 dBFS
  • Total Posts : 104
  • Joined: 2014/11/30 03:00:06
  • Status: offline
2016/09/12 23:13:37 (permalink)

How to convert two mono tracks <--> One stereo track.

Hi folks!
Good morning? :)
 
I'm using sonar platinum and I want to convert two TRACKS into one stereo TRACK, and vice versa.
 
Clip is NOT the case.
 
I mean, I would use this function for VSTI like addictive drums2.
 
I loaded up AD2 with all output(mono), But I want to make two mono room channel or overhead channel into one stereo channel.
 
I hope this can be done!
 
Please give a advice!
 
Thanks!
 
Best.
SOHN.
post edited by muzdol - 2016/09/13 00:31:31
#1

3 Replies Related Threads
    scook
    Forum Host
    • Total Posts : 24146
    • Joined: 2005/07/27 13:43:57
    • Location: TX
    • Status: offline
    Re: How to convert two mono tracks <--> One stereo track. 2016/09/12 23:49:47 (permalink)
    In addition to mono outputs AD2 provides stereo outputs for room and overhead. A track template and drum map my be downloaded from http://www.cakewalk.com/Support/Knowledge-Base/2007013364/Setting-up-a-Drum-Map-for-Addictive-Drums-2-in-SONAR
     
    In the case where a synth does not provide a stereo output, one may be created using an Aux track or Bus.
    #2
    Kamikaze
    Max Output Level: -45 dBFS
    • Total Posts : 3013
    • Joined: 2015/01/15 21:38:59
    • Location: Da Nang, Vietnam
    • Status: offline
    Re: How to convert two mono tracks <--> One stereo track. 2016/09/13 03:07:38 (permalink)
    Select track - Overhead: Left (Mono), go to the Audio In menu, select - Addictive Drums > Overhead: Stereo. Then on the track inspector of console, set the Interweak to stereo. Rename Track
     
    Then Delate the next track - Overhead: Right (Mono)
     
    At the base of each fader in Addictive drums own mixer is a down arrow. You can choose to if the tracks routes with/without or thru the AD2 mixer. (I bypass it and select - Separate out (pre-fader), but keep the Master out routed as a stereo pair Sonars Console, so I can listen to the AD2 kits)
     

     
    #3
    muzdol
    Max Output Level: -88 dBFS
    • Total Posts : 104
    • Joined: 2014/11/30 03:00:06
    • Status: offline
    Re: How to convert two mono tracks <--> One stereo track. 2016/09/13 03:15:05 (permalink)
    Wow thanks guys. Very helpful!!
    #4
    Jump to:
    © 2025 APG vNext Commercial Version 5.1