Inspector follow issue.

Eric Beam


Inspector won't seem to follow a track via track view after clicking on a bus via the console view. The inspector stays on the last bus selected via the console. If you go back & click on a track or hide/show the inspector it clears.
Anyone else confirm this? X1c

Confirmed. I had this happen earlier and didn't understand what I had done to produce it.

If I go to the console view, click on a bus, then back to the track view and click on a track, It won't highlight the track and therefore won't show up in the inspector. I have to actually click in the content area of the track I want to select to get it to highlight or close and re-open the inspector. After that I can click on any track the way I normally do to select them.. Just never after first selecting a bus in the console view.

Good find Eric.

I did find a way around this. I clicked the buss icon and it allowed for selecting the track after I did that. None the less this is not the way it should work.

Inspector won't seem to follow a track via track view after clicking on a bus via the console view. The inspector stays on the last bus selected via the console.

I saw this when I first tried it in the project I had open at the moment, but now cannot reproduce it after saving that project and opening another. I closed and re-launched SONAR, and tried a couple different projects (including Pre-X1c and old 8.5.3 projects) and still can't reproduce it. I'm thinking there must be some other project or program state that has a bearing.

Confirmed here - has it been reported?