Klanghelm SDRR 2 and IVGI 2 released

Yay!!! I will always own anything Klanghelm makes, and always look forward to what he gives us.
Thanks for the heads up!

clintmartin
Why is my reply showing up before JonD's post?

Did you accidentally click the "Post" button in the upper-right of the message window?  (If so, just click it again to move your post back down).

Thanks!

Check the manual for IVGI 2. The controls do work as expected.  They are rather subtle.  A good thing to do is feed some pink noise into it, insert IVGI 2 then patch a spectrum analyser at the end of the chain.  Check the display while fiddling with both of those controls. The Response and also the Asym Mix control. They do work a bit together. It is based on the Desk sound and operation of SDRR 2.

This is a nice treat! I haven't used SDRR1 for a while, as I have other options, but I loaded SDRR2 on a guitar bus to tame a bit of harshness and it worked very well. I also put it on a bass track in the same mix and it added a nice roundness and solidity to it.
 
Thanks Mr. Klanghelm!

06/16/17 version 2.0.0
- initial release
- changes compared to SDRR 1:
- new plugin-ID, so you can use SDRR 2 and SDRR 1 at the same time
- switched to JUCE-framework
- new GUIs
- GUI-resizing
- reworked VU meter, uses the engine of VUMT 2 now
- Automatic Gain Compensation option, similar to the one used in MJUC
- critically revisited all modes
- reworked dynamics section of TUBE, DIGI and FUZZ modes to be less quirky
- in DESK mode the TRANSIENTS control now works more obvious and and similar to a traditional transient shaper
- redesigned compressor in DESK mode:
- it is now a VCA type compressor with RMS detection and program dependent attack and release
- three switchable attack and release behaviors (slow, medium, fast)
- also, a gain reduction meter has been added to the COMP section
- the dry (unprocessed) signal is now pre-trim
- new HQ-mode:
OFF: non-oversampled operation, uses significantly less CPU than before
ON: low-latency oversampling (4 samples), corresponds to SDRR 1, but still uses
slightly less CPU in many situations than in version 1.
FUZZ mode uses up to 20% less CPU
ON+: more detailled modelling and linear phase oversampling filters used for this option
- new preset-browser, just like the one used for MJUC and VUMT, incl. easy copy/paste/save-as-default...
- new presets
- AB-ing
- global settings with options to
- show/hide editable value readouts
- customize mouse-drag behaviour
- show/hide tooltips

I also just noticed that MJUC was updated from v1.1.0 to v1.1.1 on 23 Feb 17. Missed that one somehow.
 
02/23/17 - version 1.1.1
- FIX: crash in Tracktion/Waveform when enabling HQ mode in MJUC
 

Thanks TM.

TheMaartian
I just noticed that the SDRR2 install only included VST2 versions (.DLL), no VST3 versions.

 
It does not matter. You can use it, that is all that counts.  Many VST3 options are not really offering anything much.