Was recently able to succesfuly convert an Audio bass line into Midi using TTS-1.
The only problem I had was that a few notes were not playing.
When viewing in the piano roll mode, I noticed that the notes not playing were G2, A2, B2 and E2.
What could be the problem? And is there a solution to it?
Everything works great except for these four notes.
 
Thank you in advance for any reply and solution to this issue.
 
Regards
 
Gerry.

Transpose it up +12 I think those notes are below the range of the player.
For good bass sounds try the SI Bass and the Jazz Bass patch,, much better than TTS-1

Any particular patch? I did not think TTS-1 had a problem with note range like the sfz synths. I tested several of the bass patches in TTS-1 and they all played MIDI note 0.
 
Check Preferences > MIDI > Playback and Recording "Prepare Using nnn Millisecond Buffers." The default is 250 however 500 or higher may work better.

Process: Audio to TTS-1 to SI bass and chose NICE JAZZ bass sound.
Also changed the buffer from 250 to 500 as suggested by Scook and still have the same issue.
I did transpose +12 and it seems to have somewhat corrected the problem. Not perfect, but the notes play and it is a step in the right direction.
 
Again, thank's for all inputs.
 
Gerry