hello
Can you give information how your pc and K2600xs are connected ?
Midi in/out UM one, master/slave.
Record or play back too,or from your pc.
Is the information in chap.10 in your manual clear?
Maybe a restart from scratch ?
succes
mo
 
 

Hi - can you please detail the midi output channel routing assignments you made to the midi tracks? How do you have each midi track input/output routing assignments made, and where is it and how is it that you have made each midi track have the needed correct midi channel assigned, etc.
 
I would be quite interested in you listing all the steps you did in creating this project, so we can figure out what might be missing or a little off in being configured. 
 
This is most likely some simple little thing - that seems to happen to me more and more these days :)
 
Bob Bone
 

Hi
 Because  I don't know the exact configuration of your gear I suppose your Kurzweil 2600XS
is connected at your pc via either  your M audio uno or Roland UM one.  This should be done before
you start up the CW program!!!*. Now create a NEW project (NORMAL OR BLANK and give it a name.
In the control bar go to OPTIONS and click Instruments.
In the output channel (left column) you see all the available'channels of the connected ports.
If your M audio and/or your Roland UM one are properly installed they must be seen here.
The 16 midi channels are now available and on the right you'll find all the instruments,
You can connect for example all the output ports 1-16 to general midi.
It would be fine if your Kurzweil was between them, but therefore you need an installation disk or 
DEFINE it yourself.  
Open now in the toolbox a new MIDI track, expand the track and in input /output you must find
your M audio or Roland, in the output you'll find the instrument (maybe general music)
In ch (click the triangle to choose a number 1-16.
In the PATCH choose instrument 
good luck
mo