I inserted sends on 4 tracks and adjusted, working fine. I Noticed the pan knob on one track was panned around 25R. I Set it back to Center. I then noticed other sends were panned but I did'n pan them and didn't have follow track pan active. When I set one track send pan to Center the other track sends would pan either left or right. Really strange. I turned them all off and centered each one and so far they are staying centered. The other thing that happened is I inserted a send on another track and decided to turn it off. when doing so the track got very loud. Turning the send on again brought it back to it's normal volume. I noticed that when turning of the send it's still going to the bus with the effect. Also I have the track panned hard right. With the send on the track panning it correct. When I turn the send off the tracks sound is center but the pan knob is hard right. Has anyone had this happen?
 
I should note that I am using the prochannel Rematric Solo verb on the bus. 

Offset mode?

Hey Brando, No I'm not in Offset mode. I checked to make sure. Also when I set the send to none the panning on the track is correct again. I can't figure this out.

I am unable to duplicate this. Can you make a video to demonstrate this?

I feel real stupid. I was turning the blue button on and off. I just realized that's the pre and post fade. DOH!! I have to blame this on the new design change. OK, is that fair? The up side is that Platinum is working very well. I really don't mind user error...