Hi
I have been using a VS-100 for I/O and controller for years. I have just bought a VS-700R to use for my I/O but I would still like to use the VS-100 for extra MIDI and for the transport/fader controls.
My rig is Sonar X3c on Windows 8.1 64-bit. I eventually managed to get the firmware updated and 2.0.2 drivers installed for the VS-700R and it is seen by Windows OK.
Initially when I went to enable the drivers in Sonar for the 700 they were greyed out and I couldn't select them to enable. I had to switch off my VS-100 and reboot, then when Sonar complained about no audio device configured I could then go in and select the VS-700R.
Does anybody know if it is possible to run a VS-100 alongside a VS-700R?
Thanks