• SONAR
  • (Solved) No singal showing on master bus and hardware outs
2017/07/16 01:42:11
Mosvalve
When I record a track say guitar, I see the signal in the track I'm recording but no signal on the master bus and hardware outs in Sonar. I can't figure out why. Anyone had this happen. I have the latest update. I don't recall this happening in the previous update. I haven't had a chance to roll back to previous version yet.
 
Thanks
2017/07/16 09:42:14
Bristol_Jonesey
Where is the output of the track routed to?
Are your master bus faders at 0dB?
Any plugins on the master buss?
2017/07/16 14:46:59
Mosvalve
Bristol_Jonesey
Where is the output of the track routed to?
Are your master bus faders at 0dB?
Any plugins on the master buss?


Output of track I'm recording is going to master bus. There are no plugins on master or the recording track. All faders are at unity 0db
2017/07/16 15:13:18
Mosvalve
OK my bad. I don't monitor through Sonar(input echo) so it turns out when monitoring through my interface software the signal doesn't show in the master bus. If I use input echo the signal shows in the master bus. I never noticed this before. So I am assuming I am correct on this and will mark the threat solved.
 
© 2026 APG vNext Commercial Version 5.1

Use My Existing Forum Account

Use My Social Media Account