Hopefully this is the right forum.
After the latest Windows 10 update I powered up my Behringer X touch opened up sonar open up a project and nothing. It works with the on-screen commands and with the mouth but not with the X touch. Preferences control service Mackie emulation In-N-Out ports x touch.
Anybody else experienced this and figure it out?
Thank you
WSS

Westside Steve Simmons
Hopefully this is the right forum.
After the latest Windows 10 update I powered up my Behringer X touch opened up sonar open up a project and nothing. It works with the on-screen commands and with the mouth but not with the X touch. Preferences control service Mackie emulation In-N-Out ports x touch.
Anybody else experienced this and figure it out?
Thank you
WSS

Happened to me yesterday. It was working the night before and I had my computer disconnected from the internet, so I don't think it was an update.
 
I redid the power up X-Touch with channel one "Select" button held down, selected Mackey and USP, hit the select button again and then went into preferences to select parameters you stated. I had to redo my functions and after closing Sonar and repowering the X-Touch, everybody was happy.
 
Walt

Thanks Wally. I'll take a shot at that.

Steve, did it work?
 
Is this the Creator's Update for Windows?  That hasn't been thrust upon me yet but otherwise I'm up to date with all drivers, and my X-Touch is working.
 

Not exactly sure which updated is it just showed up. Actually old pal I'm up here in the Cleveland Clinic for a couple more days and will take a shot when I get back.
WSS

Uninstall Re install Power up channel one select MC USB channel one select Open project reset preferences and we are off to the races. Thank you gentlemen.
WSS

Works fine now
WSS

Good!