I realize that recording is a rather minor function in a studio, but I would like to do it once in a while.
 
Sometimes, Sonar stops recording:
1-Select the proper track.
2-Enable record on the track.
3-Hit record.
4-Hear the metronome and start recording.
5-Hear the instruments and see the meters moving.
6-Stop the transport and there is nothing on the track.
7-Undo does not undo recording, but whatever was done previously.  It's as though the recording even never happened.
 
Thoughts?

.

Can't help with the why, but that happens to me occasionally too, so at least you can feel a little better that you're not alone. Everything looks normal until I press stop and then......wtf? Where's the clip ? Sometimes there's a tiny little slither of blank clip at the start like it started recording but just switched itself off again. Usually it works ok when I just  try again - no reboot required - but it is very annoying when it happens. I had dared to think that it might have stopped happening as it's been a while, but then yesterday it did it again - very sparse project so it can't be a lack of system resources thing.
 
2016.12 win 7 if it matters.

Make sure punch recording is not enabled.

Scook, Although I never use pnch recording, oddly it was on and that was the problem.  Thanks.