NEW MIDI LOOP MONSTER BUG

  Sonar X2a. W7. Octacapture. Looping part of song with both audio and midi instr tracks. After about 10 minutes of continuous looping I encountered two problems: 1) Instrument tracks all of the sudden wont allow me to bounce midi takes to single clips. The multiple takes merge temporarily into a single window as expected... but when I minimize the now-merged window in track view and then reopen it, all the individual takes reappear as separate clips in different take lanes. If that isnt annoying enough, after the ten minute mark, bounce to clips takes a whole lot longer, like almost as if I'm bouncing real audio tracks. And then.... 2) After about 5-10 minutes of dealing with this, all of the sudden I lose my right channel in my monitors. It's not the speaker b/c if I open spotify while in session, all is fine. Anything non-Sonar fine. I have a monitor controller, so I can select between different sources that all use the Octacapture soundcard...the problem is solely in X2. It literally glitches on a loop with midi and then crackles out to no sound. Left channel is fine. It's not defaulting to mono, whole right side farts out. I have confirmed and reproduced both problems. Seem related### Loop a four bar phrase with both wave and an instrument track...record instrument takes with rollover setting for continuous recording. Repeat a few more takes and then do the bounce to clips. Then delete all midi data and start over. After about 10 minutes you will lose your right channel!!!! Reproduced bug it 3 times in a row each time starting with fresh reboot of comp and octacapture!!!