Problem with 4.0.3 and UAD automation

Author
Post
Essentials Only Full Version
Axiology
Max Output Level: -86 dBFS
  • Total Posts : 246
  • Joined: 2004/12/10 18:23:51
  • Location: Row J Seat 12
  • Status: offline
2005/08/02 17:17:10 (permalink)

Problem with 4.0.3 and UAD automation

I'm having a problem that seems to have come up following the upgrade to 4.0.3. I'm using automation to change the frequency of a low-pass filter on the UAD Cambridge EQ. I had frozen the track while using 4.0.2 and it was working fine then. Now, after the upgrade I unfroze the track to make a minor change and the automation for the Cambridge doesn't work. I have two four bar sections of a bass line where I want the low pass frequency to change from 250Hz to 1 Khz. Instead the change is occuring at the end of the section. I tried deleting and recreating the automation but that didn't help.
If I place the cursor in and out of the section where the EQ change occurs without starting playback I can see the EQ on the Cambridge changing, but it won't do it while in playback or if I freeze the track.

Andrew
http://www.soundclick.com/bands/1/axiologymusic.htm



#1

3 Replies Related Threads
    Axiology
    Max Output Level: -86 dBFS
    • Total Posts : 246
    • Joined: 2004/12/10 18:23:51
    • Location: Row J Seat 12
    • Status: offline
    RE: Problem with 4.0.3 and UAD automation 2005/08/04 20:44:06 (permalink)
    I've solved my problem, or at least have a good work-around. I was using jump mode on the automation. I changed to linear and now it works. Jump mode worked fine in 4.0.2.

    Andrew
    http://www.soundclick.com/bands/1/axiologymusic.htm


    #2
    Tripecac
    Max Output Level: -58 dBFS
    • Total Posts : 1702
    • Joined: 2004/01/27 16:45:15
    • Location: New Zealand
    • Status: offline
    RE: Problem with 4.0.3 and UAD automation 2005/08/06 11:58:11 (permalink)
    What's jump mode? Is that a setting on your hardware or in Sonar? Do you mean a jump envelope? [ http://forum.cakewalk.com/tm.asp?m=546879 ] ?

    I'm noticing automation problems after 4.0.3 too.
    post edited by Tripecac - 2005/08/06 12:22:42
    #3
    Tripecac
    Max Output Level: -58 dBFS
    • Total Posts : 1702
    • Joined: 2004/01/27 16:45:15
    • Location: New Zealand
    • Status: offline
    RE: Problem with 4.0.3 and UAD automation 2005/08/12 15:06:13 (permalink)
    Axiology, have you found any other workarounds other than replacing jumps with slopes?
    #4
    Jump to:
    © 2024 APG vNext Commercial Version 5.1