Problems with BCF200 connecting to Sonar
I am using Sonar Producer 8.53, a Behringer BCF2000 as my control surface, and Windows 7 64-bit.
My question is whether the problem I'm seeing is a sonar issue, Behringer issue, or there is something else I need to do.
Basically I am observing that if I follow these steps, the BCF will control parameters in a Sonar project:
1. turn on the BCF2000 with Sonar emulation mode (by holding down the 4th button in the top row of buttons while turning on the power).
2. Open Sonar
3. In Sonar, go into Options / Controllers and add the BCF2000 as a mackie device running on Behringer port 1 for input and output.
4. Open a project, and the knobs, buttons, and faders of the BCF2000 will control Sonar parameters as expected.
Now, here is the rub and what I don't understand. If I then close Sonar, turn off the BCF2000 and go through the same process as above, the BCF2000 will not control the parameters in a Sonar project.
I have found that in order to get the BCF2000 working again, I have to get into Sonar's Options / controller dialog again and delete the Mackie controller hooked to the BCF2000. If I now re-add a new Mackie controller in this dialog for the BCF2000, then the BCF2000 will be able to control the parameters in a Sonar project again.
I don't think I should have to delete and add the BCF2000 Mackie controller within Sonar each time I re-open Sonar and/or cycle the power on the BCF2000.
Question: Am I doing something wrong here or is this a bug with the BCF2000 Sonar emulation mode or a bug with Sonar itself?
--Pete