Helpful ReplySaffire Pro 24 Not selectable

Author
Post
Essentials Only Full Version
koreabsorb
Max Output Level: -90 dBFS
  • Total Posts : 24
  • Joined: 2013/02/13 21:32:19
  • Status: offline
2014/05/16 15:07:10 (permalink)

Saffire Pro 24 Not selectable

Just upagraded to X3 Studio, when I go to select Pro 24 as audio device it is listed but grayed out and does not allow me to select. So, I cannot hear any audio.  Any advice?
#1
List Solutions Only

2 Replies Related Threads
    scook
    Forum Host
    • Total Posts : 24146
    • Joined: 2005/07/27 13:43:57
    • Location: TX
    • Status: offline
    Re: Saffire Pro 24 Not selectable 2014/05/16 15:16:22 (permalink) ☄ Helpfulby Mystic38 2014/05/16 18:52:26
    If running ASIO driver mode disable any other input and output device. The ASIO specification permits using only one I/O driver at a time.
    post edited by scook - 2014/05/16 19:09:19
    #2
    bitflipper
    01100010 01101001 01110100 01100110 01101100 01101
    • Total Posts : 26036
    • Joined: 2006/09/17 11:23:23
    • Location: Everett, WA USA
    • Status: offline
    Re: Saffire Pro 24 Not selectable 2014/05/16 18:01:31 (permalink)
    Go into Device Manager and make sure the interface shows up there under Sound, Video and Game Controllers. If it isn't, then Windows doesn't know about it and therefore SONAR can't talk to it. That would most likely be because the driver isn't installed properly. If it does show up in Device Manager, open the Sounds control panel applet and see if the interfaces is listed there. If not, it could also be that the driver isn't installed properly. IIRC when I installed my Saffire there were actually three separate drivers that had to be installed (audio, MIDI and S/PDIF).
     
    I'd also check that the firewire cable is seated properly at both ends. 


    All else is in doubt, so this is the truth I cling to. 

    My Stuff
    #3
    Jump to:
    © 2025 APG vNext Commercial Version 5.1