Trouble with erasing transient markers in Loop Construction View
I'm running a 64bit version of Sonar X1b on a Vista 64 OS Setup.
I did not have this problem with Sonar 8.5 or earlier.
While working on Groove Clips it's a bit bizarre but the Erase Transient Select tool doesn't work. No matter how many times I click on it, it doesn't seem to respond. In other words Erasing transients cannot be used. Perhaps this is going to be fixed but I thought I'd best see if there is a solution. I have found an alternate way of dealing with this by using the resolution or moving transient markers on top of other markers, but it only messes me up if I have inserted maybe a few too many markers then I'll have to start over or I have to move them around on top of other red markers to get rid of them or overlap them if they are greyish violet markers. I'm not even sure if this is good for the clip or even aware that the more makers I have used may add pressure to the CPU performance, especially if I have loads of groove clip files with lots of transient makers in the project using up valuable resources.
I've contacted tech Support and they suggested to upgrade from X1a to X1b, I tried that and replied back to Sonar Technical that this didn't work.
It's been a over a week and I have no reply back from them. So while I'm still waiting for a reply maybe it would be quicker to leave a thread here to get an answer. I had a few other queries as well in my original email I sent to Sonar Technical to look into, perhaps that's why they are taking so long to reply and going to send me a response covering everything all at once. I'm going to add these as well to the forum.