Using hardware EQ / USB Audio interface, Wiring ?
Hi i borrowed a
Behringer Tube Ultra Q T1951, hardware EQ, from someone i know
Well i have never used hardware before
Now i will use sonar and re track audio.... through this hardware EQ.
Using my line's L / R out, on the Audio Interface (
Steinberg Ci1 ), and in to the
Hardware EQ input's 1 as ( left ) and 2 as ( right )
EDIT : first problem i encountered was, a to hot signal with the XLR's cables, from the EQ
and in to the Audio interface ( signal was distorted )
so i switched to Jack cables ( mono cables ) ,the audio is still hot, but i can raise the
input gain on my Audio Interface now, without any distortion so recording will be ok.
Problem now, is that i cant monitor the signal from the EQ
just the ordinary signal that is going to the headphones out of my Audio Interface
and to my stereo amp. ( monitoring )
How is a setup like this done , using a Patchbay ? / split of the outputs from the Hardware EQ ?
1 set into the Audio interface, and 1 set to my Monitoring ?
Tips welcome...
Jan
post edited by Soundblend - 2014/10/14 19:24:32