So you have your room set up and think you have it tuned up for sound.

Then ya' hang a few acoustic guitars on the wall.

Now when your mixing do you run into probs kinda like having a drum kit in the same room with the resonator heads installed and listening at louder levels while mixing creating unwanted noises, resonations while working.

Outside of removing them from the room, what have ya tried ?

Intertwine a pipe cleaner or similar around the stings of all guitars

Blankets on the drums.


best regards,
mike

Bristol_Jonesey


Intertwine a pipe cleaner or similar around the stings of all guitars

+1. I use a couple of picks

I hang pictures of guitars on the wall rather than actual guitars.

bitflipper


I hang pictures of guitars on the wall rather than actual guitars.

bitflipper


I hang pictures of guitars on the wall rather than actual guitars.

So what do you do with your guitar stands then if they haven't got pictures in like mine?

Take some pieces of fabric or sponge and slide them under the strings at the bridge and neck.

If it is just the snare resonating turn it upside down and put towel over the trap. If it is all the other drums too put towels on all the heads. This won't stop the bottom heads from vibrating but it should reduce the noise significantly. Cheers.

bitflipper


I hang pictures of guitars on the wall rather than actual guitars.

E-Drums
E-Guitars
E-Studio


Simples

bitflipper

I hang pictures of guitars on the wall rather than actual guitars.

Hopefully they're not printed on high bright high gloss paper. It's reflective properties could make your sound waves bounce around.