Hi all, while in play, power button on a ProChannel module will not turn off, stop  playback and it will turn off but on returning to play module turns itself back on. This has happened to me in two projects now, both with breverb.

Any thoughts ty

I should add not all buttons wont turn off just some buttons within a strip
 

This has happened to me before I'm sure. I've also seen the PC-2A module continue to operate (needle moving, audio compressing) when the power button is switched off. Never been able to reproduce at will and in all cases the problem was fixed by removing and replacing the module.

Thanks for confirming
Yes removing and replacing the module is a (kind of) fix.
Next time this happens, to avoid loosing settings I'll try saving strip as a preset and reloading.  

I have a problem where sometimes the Concrete Limiter gets stuck on maximum reduction so no signal gets through. As with Sharke, I've found the only foolproof workaround is to replace the module and re-create the settings. I try to save projects where this happens to send to Cakewalk for analysis, but if you open it from the closed state, the problem isn't there.

Thanks Craig
Would be interesting if saving the preset would make it reproducible, I'm sure the bakers would like a copy of it.

Thanks for the suggestion! I'll see if I can save a preset while it's in the messed-up state.