Hey all - a lot of good recommendations here. Thanks all!
My vocal take is actually good, so, not a lot of correcting needed from my Rode NT100 condenser mic--just the HP and LP roll-offs. I just used some compression to even out the levels a little.
What I was hearing is, I just thought it needed a little polishing, if I can use that term.
What I ended up doing is sending less signal to the reverb bus, and added the Maserati VX1 at the beginning of the fx chain (not really a chain-a bus insert). I've now got VX1 (zero comp setting) --> Lexicon MPX1 reverb --> UAD Pultac Pro EQ --> UAD Precision Bus Compressor. Might seem like a strange grouping with more than one EQ and reverb, but I dialed them in to taste without overdoing it.
I like the parallel compressor technique, but the above seemed to sit well in the mix, so I'm good with it.