I'm trying to control a TH2 amp sim with a Behringer FCB1010 foot controller modified with the Uno chip. I want to use the FCB in Stomp box mode. I have a editor installed on my computer to make the process of programing easier. Well it's not. I need cc data to turn the stomps on and off and one for each stomp, reverb ,delay , etc. No documentation anywhere states what the cc numbers should be. The TH2 manual states I need to input these, but doesn't say what the numbers are. I have been all over the internet and can't seem to find anything helpful.
 
BC

It is because Overloud does not know what CC numbers are being sent by the controller. It is up to you to determine which numbers are sent by the controller and map them to the functions in the TH2.

May I suggest using the word 'Midiot' in future.
 
I, for one, am a self-confessed midiot.
 
F.

BC,
I just looked through the TH2 manual - and I don't see anything about a stomp box mode - only that you can directly call up programs.
 
Brian

Stone House, it's the fcb controller that has stomp box mode. I should be able to turn effects on and off instead of just switching patches.
 
 Frink, lol. Yes, I'm a midiot.
 
  Scook, this is what confuses me. Mapping. I have to map the cc numbers to TH2. What numbers. What is the cc number to turn an effect on and off.
 
 

BC,
I understand what you're saying, I have an fcb myself.  What I mean is, I don't see anywhere in the TH2 documentation that says you can switch effects off and on - only that you can change patches, or variations.  If you can point me to the documentation from Overloud for fx on/off mode, I should be able to help you figure it out.
 
Brian

Stone House, I saw a video on Youtube which showed the use of the smart controls. In the midi bindings there is a smart control midi learn and cc/note field.