apologies if this has already been covered but i have an issue with sonar x2 and my guitar rig mobile device.  When i go to select audio device it only shows guitar rig left as options for both input and output. This issue is specific to x2 as x1 on the system shows both left and right channels. any help appreciated

which driver mode are you using? if using ASIO it will only show, for example:

Guitar Rig 1 L
Guitar Rig 1 R
Guitar Rig 1 Stereo

the "L" is the left input, the "R" is the right input and of course "stereo" is both of them for a stereo track.

if that's not what you're seeing, which driver mode are you using?  have you tried any other driver mode?  some companies don't write drivers for WDM any more or they don't support them any more and that could cause problems.

I'm using the asio driver. Its all x2 shows is guitar rig 1l. Running x1 on the same PC shows the 3 as you have listed above

check in X2 and make sure that you don't have some of them disabled in the PREFERENCES

in preferences the only listed option is guitar rig 1l, the other 2 dont show up at all to select, as i said, on x1 on the same system all 3 show up fine

try changing the driver mode to WDM and see what happens.

the devices show up correctly using wdm but the latency makkes it unusable

did you try moving the latency slider to the FAST side?

ive left it with technical support for now. time to dig out the vs20 again. waiting on a new laptop so ill try again with a clean install when that turns up. thanks for the help

sounds like a plan since it works correctly in X1 but not X2.