I moved my whole setup to Windows 7 64-bit and I can't get Dimension Pro to behave. It keeps throwing errors when I try to insert it into a project. Is there a 64-bit update/patch somewhere I missed? I've reinstalled a couple times and allowed it to select its own install folders (just to rule that out).
 
Thanks folks!

In order to completely remove Dimension Pro from your system you need to follow the guidelines below.

If you do this, it should install without a hitch

http://www.cakewalk.com/S...reader.aspx/2007013238

Also, if you're installing it from a separate download and not as part of Sonar, you MUST run the installer "As Administrator"

Bristol_Jonesey


In order to completely remove Dimension Pro from your system you need to follow the guidelines below.

If you do this, it should install without a hitch

http://www.cakewalk.com/Support/kb/reader.aspx/2007013238

Also, if you're installing it from a separate download and not as part of Sonar, you MUST run the installer "As Administrator"

Fantastic! I'll give this a try. I am installing the Dimension Pro from the disk and SN that came with Sonar.
 
Thank you!

Check your Caekwalk Account - you might find there's an updated version of Dimension Pro available for download.

The version which shipped with the original DVD's for version 8.5 was, I believe, Dim Pro version 1.2

They released an update to 1.5 which is the current version.

But you do need to do the registry tweaks I linked to above before attempting to install it.

Bristol_Jonesey


Check your Caekwalk Account - you might find there's an updated version of Dimension Pro available for download.

The version which shipped with the original DVD's for version 8.5 was, I believe, Dim Pro version 1.2

They released an update to 1.5 which is the current version.

But you do need to do the registry tweaks I linked to above before attempting to install it.

Again, many thanks.