DDLY 1.01 out

2016/02/27 20:50:33

robbyk

Eddie TX
This is a cool plugin. One thing I can't figure out is how to pan the effect. I watched the Groove3 vid where he sets up a stereo delay using two instances, but I didn't see how he panned them L/R. Anybody know?

Cheers,
Eddie

That is a great question, they are both on the same bus so it can't via the sends...

2016/02/27 21:41:19

Fleer

bapu
scook
Happened to me too. I ended up logging into my account to get the update. The UI is slightly better.

czech

slow vac

2016/02/27 22:56:06

Jeff Evans

Set up two Buses with an instance of the delay on each. From one channel create two sends and send the same signal into the two buses at once. Pan the delays at the buses. Good thing about this is you still have the dual delay effect working from within one instance but set up different settings for left and right.

2016/02/27 23:32:18

Eddie TX

Jeff Evans
Set up two Buses with an instance of the delay on each. From one channel create two sends and send the same signal into the two buses at once. Pan the delays at the buses. Good thing about this is you still have the dual delay effect working from within one instance but set up different settings for left and right.

Yes thanks Jeff, that'll work, but it does seem like there must be some hidden feature that allows panning, given what was set up in the Groove3 video. I won't rest until I know the secret!!

Cheers,
Eddie

2016/02/27 23:43:27

Jeff Evans

I am not sure on that Eddie. The thing is in those videos you never see the host DAW and how he had it setup so we may never know. I can contact Bill over on the Presonus forums and ask if you like and report back.
I am sure Bill would have mentioned panning and if it was possible. He is very thorough and tends to explain every single feature on something like this. Maybe the WIDE sort of does it a bit perhaps. I will check with Bill himself and get back to you here.