zaboomafoo1984
Excuse me for my english.. I have Sonar X1, and Addictive Drums 2. When I set the "multioutput" mono or stereo.. and check the output in the AD2. I only have 2 tracks of the Master Stereo workings.. the other 16 are freeze. I choose every combination of Sonar (All Mono output, All Stereo Output) in the AD1 its very easy.. and work.. but in the AD2. the tracks are freeze.. and only works 2 outputs (The masters) any suggestions?

Are you assigning the outputs of each channel in AD2 to the associated tracks created in Sonar?
At the bottom of each track on the AD2 mixer is an output assignment that has to be set to the corresponding
track created by Sonar.

 
Thanks Cclarry for this answer.. yes i do this. I assign the output to the associated tracks in sonar. But when i play.,. i only hear the stereo tracks.. Its the same method in AD1, and works for my too. But in AD2 and Sonar.. only hear the master track of AD2. Any other suggestions?.. I run this method in other secuencer.. and works fine.. but in sonar.. no

Thanks Cclarry for this answer.. yes i do this. I assign the output to the associated tracks in sonar. But when i play.,. i only hear the stereo tracks.. Its the same method in AD1, and works for my too. But in AD2 and Sonar.. only hear the master track of AD2. Any other suggestions?.. I run this method in other secuencer.. and works fine.. but in sonar.. no

I had this problem also when I first started using it.  You have to select
"All outputs Mono" or "All Outputs Stereo" from the Sonar MIDI Synth Dialogue,
and then, make sure your are selecting "Separate Out" from Each Track within
AD 2...that should do it!

Here's something else I find quite odd...and I'm probably overlooking something obvious
Once I'm set up with a "blank" Project and I insert AD2 into the Project and have everything
routed.  When I play a kit piece, they ALL show the appropriate levels in the respective
meters on BOTH AD2 and in the Sonar Mixer where NOTHING has been touched.  Yet,
the Master Meter is Peaking in Sonar, even though the Master Meter and all the levels in all
in BOTH X3 and AD2 tracks are showing the appropriate levels. No effects chains of any kind
have been turned on, and everything is at default.

I would assume (dirty word) that ALL the Meters should (appropriately) show the same levels
across the board.  Will have to dig further into this...
 

Ohhh I do the same.. and dosnt work.. i want to show you an screenshot.. that i do.. its very rare. Because in another secuencer its work.. but in Sonar X1.. the routing in AD2 not work for me. I put this settings in the Midi Synth Dialogue.

Might be something specific to X1 and AD2 then....as I don't have that problem in X3...
As long as everything is being set up correctly...

im having trouble finding what path to send it to, any help? and hope that will help with the midi I/o but ive been trying to figure this out for 3 days and about ready to toss it