sonar x3, Kontakt 5, and pitch wheel

Incidentally if I use one of the sonar bundled soft synths  (SI-String Section) pitch bend works fine.

I should point out that NONE of what I had written in that other post dealt with any part of pitch bend event handling whatsoever.
 
If pitch bend is working for you in Kontakt, it will be simply because whatever instrument preset you have loaded happens to have its parameters set to react to pitch bend events.
 
Quite simply put - in Kontakt, some instruments are set up to react to pitch bends, and some are not.
 
In the past I had some problems with some Kontakt instruments not being set to respond to Pitch Bend data, which hadn't been a problem until I worked on a project needing to bend some bass notes, and found it just didn't respond.
 
 
What I found I needed to do, was to open up the particular instrument's controls within the Kontakt multi-rack, and set it to react to Pitch Bend events, and save it as a new preset in Kontakt, so as not to alter the original factory settings.
 
Once I did the above, I could load up the newly-created preset and it would then react to pitch bends exactly as I had set it up to do.
 
I hope that helps.
 
Bob Bone
 

For whatever the worth, Key Switches are visible on the little keyboard at the bottom of the Kontakt instance UI, and you can also expose and change them within the multi-rack for a given loaded instrument, if that helps any.
 
Bob Bone